Yaskawa VS-616G5 Modbus Plus Communication Card - Manual (Page 113)

Data Registers A-33
Drive Parameter Registers (Read/Write) – continued
REGISTER PARAMETER PARAMETER PARAMETER LIMITS / DESCRIPTION INITIAL
(in hex) FUNCTION SETTING VALUE
500h o1-01 Monitor Selection 4 to 25, 28, 32, 33 6
501h o1-02 Monitor Selection after Power-up 1 Frequency Reference
2 Output Frequency 1
3 Output Current
4 Selected Monitor
502h o1-03 Digital Operator Display Scaling 0 to 39999 0
503h o1-04 Digital Operator Display Units 0 Hz 0
1 RPM
504h o1-05 Parameter / Address Display 0 Parameter Number 0
Selection 1 Modbus Address
505h o2-01 LOCAL / REMOTE Key 0 Disabled 1
Selection 1 Enabled
506h o2-02 STOP Key Function during 0 Disabled 1
Remote Run 1 Enabled
507h o2-03 User Parameter Default Value 0 Disabled
1 Set Default 0
2 Clear all
508h o2-04 kVA Selection (Drive Model No.) 0 to FFh (1)
509h o2-05 Digital Operator 0 Drive accepts freq. after ENTER key 0
“Motor Operated Pot” 1 Drive accepts freq. immediately
50Ah o2-06 Operation Selection when Digital 0 Disabled (operation continues) 0
Operator is disconnected 1 Enabled (motor coast to stop; fault)
50Bh o2-07 Elapsed Operating Hour Timer Set 0 to 65535 hours -
50Ch o2-08 Elapsed Operating Hour Timer 0 Timer active when power applied to drive 0
Selection 1 Timer active when drive is in run mode
50Dh o2-09 Initialization Mode Selection 0 Japanese Spec.
1 American Spec. 1
2 European Spec.
Notes (for this page only):
(1) Not initialized. Initial value differs depending on the drive capacity.