H3C Technologies H3C SecBlade LB Cards - Manual (Page 69)

59
Configuring the device name at the CLI
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the device name. sysname sysname The default device name is H3C.
Changing the system time
You must synchronize your device with a trusted time source by using NTP or changing the system time
before you run it on the network. Network management depends on an accurate system time setting,
because the timestamps of system messages and logs use the system time. For NTP configuration, see
"Configuring NTP."
In a small-sized network, you can manually set the system time of each device.
IMPORTANT:
If you reboot the device, the system time and date are restored to the factory default. To ensure an accurate
system time setting, you must change the system time and date or configure NTP for the device.
Configuring the system time in the Web interface
System time allows you to display and set the device system time, time zone, and daylight saving time on
the Web interface. The device supports setting system time through manual configuration and automatic
synchronization of NTP server time.
Displaying the current system time
Select System > System Time from the navigation tree to enter the System Time tab page, as shown
in
Figure 41 . The current system time of the device appears on the page.
Figure 41 System time page
Configuring the system time
1. Select System > System Time from the navigation tree.
The System Time page appears as shown in
Figure 41 .
2. Click the System Time Configuration text box.
The calendar page appears.