H3C Technologies H3C SecBlade LB Cards User Manual
Page 166
156
Enter < Storage Device Operation > to select device.
===========================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Restore to Factory Default Configuration |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Clear Super Password |
|<9> Storage Device Operation |
|<0> Reboot |
============================================================================
Ctrl+Z: Access EXTEND-ASSISTANT MENU
Ctrl+C: Display Copyright
Ctrl+F: Format File System
Enter your choice(0-9): 6
If the Skip configuration flag is set successfully, the following message appears:
Flag Set Success.
3.
When the EXTEND-BOOTWARE menu appears again, enter 1 to run the system software image.
The device starts up with empty configuration.
4.
To run the original next-startup configuration file, perform a configuration rollback in system view.
Skip this step if you want to use empty configuration.
[H3C] configuration replace file startup.cfg
Current configuration will be lost, save current configuration? [Y/N]:n
Info: Now replacing the current configuration. Please wait...
Info: Succeeded in replacing current configuration with the file startup.cfg.
5.
Configure a new console login password.
This example uses the password authentication mode and the authentication password 123456.
For security purposes, the password is always saved in ciphertext, regardless of whether you
specify the simple keyword or cipher keyword for the set authentication password command.
[H3C] user-interface console 0
[H3C-ui-console0] authentication-mode password
[H3C-ui-console0] set authentication password simple 123456
[H3C-ui-console0] quit
6.
To make the settings take effect after a reboot, save the running configuration to the next-startup
configuration file.
[H3C] save