H3C Technologies H3C SecBlade LB Cards - Manual (Page 64)

54
Configuration procedure
The following configuration uses a switch as an example. The configuration on a router is the same.
1. Log in to the LB module from the network device.
oap connect slot 3
Connected to OAP!
2. Configure the clock synchronization timer and the monitoring timer on the network device:
# Enable ACSEI server.
system-view
[Switch] acsei server enable
# Enter ACSEI server view.
[Switch] acsei server
# Set the clock synchronization timer from the network device to the LB module to 10 minutes.
[Switch-acsei server] acsei timer clock-sync 10
# Set the monitoring timer from the network device to the LB module to 10 seconds.
[Switch-acsei server] acsei timer monitor 10
3. Configure the LB module:
# Enable ACSEI client on the Ten-GigabitEthernet 0/0 interface.
system-view
[LB] interface Ten-GigabitEthernet0/0
[LB] acsei-client enable
Verifying the configuration
1. Restart the LB module on the network device.
oap reboot slot 3
This command will recover the OAP from shutdown or other failed state.
Warning: This command may lose the data on the hard disk if the OAP is not being
shut down! Continue? [Y/N]:y
Reboot OAP by command.
The output shows that you can restart the LB module on the network device.
2. Display the ACSEI server configuration information on the network device.
display current-configuration configuration acsei-server
#
acsei server
acsei timer clock-sync 10
acsei timer monitor 10
#
return
[Switch]
The output shows that the clock synchronization timer and monitoring timer from the network
device to the LB module are 10 minutes and 10 seconds, respectively.