H3C Technologies H3C SecBlade LB Cards - Manual (Page 56)

46
Logging in through SNMP
You can run SNMP on an NMS to access the MIB and perform GET and SET operations to manage and
monitor the LB product. The LB product supports SNMPv1, SNMPv2c, and SNMPv3, and can work with
various network management software products, including IMC. For more information about SNMP, see
System Maintenance Configuration Guide.
By default, SNMP access is disabled. To enable SNMP access, log in to the LB product through any other
method and configure SNMP login.
Configuring SNMP login
Connect the PC (the NMS) and the LB product to the network, making sure they can reach each other, as
shown in Figure 35 . This section describes only the basic SNMP configuration procedures on the LB
product.
Figure 35 Network diagram
IMPORTANT:
To make SNMP operate correctly, make sure the SNMP settings (including the SNMP version) on the NMS
are consistent with those on the LB product.
Prerequisites
• Assign an IP address to a Layer 3 interface on the LB product. By default, the LB module has the IP
address 192.168.0.1/24 configured for the interface GigabitEthernet 0/1 and L1000-A has the
same IP address configured for the interface GigabitEthernet 0/0.
• Configure routes to make sure the NMS and the Layer 3 interface can reach each other.
Configuring SNMPv3 settings
Step Command Remarks
1. Enter system view. system-view N/A