H3C Technologies H3C S12500 Series Switches - Manual (Page 418)

402
Step Command Remarks
6. Configure assert timeout time. holdtime assert interval
Optional.
180 seconds by default.
7. Configure the IPv6 multicast
source lifetime.
source-lifetime interval
Optional.
210 seconds by default.
Configuring IPv6 PIM common timers on an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the hello interval. pim ipv6 timer hello interval
Optional.
30 seconds by default.
4. Configure the maximum delay
between hello messages. pim ipv6 triggered-hello-delay
interval Optional.
5 seconds by default.
5. Configure the join/prune
interval.
pim ipv6 timer join-prune interval
Optional.
60 seconds by default.
6. Configure the join/prune
timeout time. pim ipv6 holdtime join-prune
interval
Optional.
210 seconds by default.
7. Configure assert timeout time. pim ipv6 holdtime assert interval
Optional.
180 seconds by default.
NOTE:
If no special networking requirements are raised, use the default settings.
Configuring join/prune message sizes
A larger join/prune message size will result in loss of a larger amount of information when a message
is lost; with a reduced join/message size, the loss of a single message will bring relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively reduce
the number of (S, G) entries sent per unit of time.
To configure join/prune message sizes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter IPv6 PIM view. pim ipv6 N/A
3. Configure the maximum size
of a join/prune message.
jp-pkt-size packet-size
Optional.
8100 bytes by default.
4. Configure the maximum
number of (S, G) entries in a
join/prune message.
jp-queue-size queue-size
Optional.
1020 by default.