H3C Technologies H3C S12500 Series Switches - Manual (Page 175)

159
Figure 50 Network diagram
Table 9 shows the interface and IP address assignment, and network topology scheme.
Table 9 Interface and IP address assignment
Device Interface IP address
Switch A VLAN-interface 100 10.110.1.1/24
Switch A VLAN-interface 103 192.168.1.1/24
Switch B VLAN-interface 200 10.110.2.1/24
Switch B VLAN-interface 101 192.168.2.1/24
Switch C VLAN-interface 200 10.110.2.2/24
Switch C VLAN-interface 102 192.168.3.1/24
Switch D VLAN-interface 300 10.110.5.1/24
Switch D VLAN-interface 103 192.168.1.2/24
Switch D VLAN-interface 101 192.168.2.2/24
Switch D VLAN-interface 102 192.168.3.2/24
Configuration procedure
1. Configure the IP address and subnet mask for each interface as per Figure 50 . (Details not shown.)
2. Configure OSPF on the switches in the PIM-DM domain to ensure network-layer reachability
among them. (Details not shown.)
3. Enable IP multicast routing, and enable PIM-DM and IGMP:
# Enable IP multicast routing on Switch A, enable PIM-DM on each interface, and enable IGMP on
VLAN-interface 100, which connects Switch A to the stub network.
system-view
Source
10.110.5.100/24
PIM-DM
Switch A
Switch B
Switch C
Switch D
Receiver
Host A
Host B
Host C
Host D
Receiver
Vlan-int100
Vlan-int200
Vlan-int200
Vlan-int300 Vlan-int101
Vlan-int101
Vlan-
int1
02
Vlan-
int1
02
Vlan-
int1
03 Vlan-
int10
3