H3C Technologies H3C S12500 Series Switches - Manual (Page 207)

191
MSDP configuration task list
Task Remarks
Configuring basic MSDP
functions
Enabling MSDP Required.
Creating an MSDP peer connection Required.
Configuring a static RPF peer Optional.
Configuring an MSDP peer
connection
Configuring MSDP peer description Optional.
Configuring an MSDP mesh group Optional.
Configuring MSDP peer connection control Optional.
Configuring SA messages
related parameters
Configuring SA message content Optional.
Configuring SA request messages Optional.
Configuring SA message filtering rules Optional.
Configuring the SA cache mechanism Optional.
Configuring basic MSDP functions
All the configuration tasks should be performed on the RPs in an PIM-SM domain, and each of these RPs
acts as an MSDP peer.
Configuration prerequisites
Before you configure basic MSDP functions, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure PIM-SM to enable intra-domain multicast forwarding.
• Determine the IP addresses of MSDP peers.
• Determine the address prefix list for an RP address filtering policy.
Enabling MSDP
When the system is operating in standard mode, you must configure a reserved VLAN before you
configure MSDP for a VPN instance. For more information about the system operating mode, see
Fundamentals Configuration Guide. For more information about a reserved VLAN, see MPLS
Configuration Guide and MPLS Command Reference.
Enabling MSDP globally on the public network
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable IP multicast routing. multicast routing-enable Disabled by default.