H3C Technologies H3C S12500 Series Switches - Manual (Page 313)

297
Step Command Remarks
3. Set the maximum response
delay for MLD general
queries. max-response-time interval 10 seconds by default.
4. Set the MLD last-listener query
interval.
last-listener-query-interval interval 1 second by default.
Configuring the parameters for MLD queries and responses in a VLAN
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VLAN view. vlan vlan-id N/A
3. Configure MLD query interval. mld-snooping query-interval
interval
125 seconds by default.
4. Set the maximum response
delay for MLD general
queries.
mld-snooping max-response-time
interval
10 seconds by default.
5. Set the MLD last-listener query
interval.
mld-snooping
last-listener-query-interval interval
1 second by default.
Configuring the source IPv6 addresses for MLD queries
CAUTION:
The source IPv6 address of MLD queries might affect MLD querier election within the subnet.
To configure the source IPv6 addresses for MLD queries:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VLAN view. vlan vlan-id N/A
3. Configure the source IPv6
address for MLD general
queries.
mld-snooping general-query
source-ip { ipv6-address |
current-interface }
FE80::02FF:FFFF:FE00:0001 by
default.
4. Configure the source IPv6
address for MLD
multicast-address-specific
queries.
mld-snooping special-query
source-ip { ipv6-address |
current-interface }
FE80::02FF:FFFF:FE00:0001 by
default.
Configuring MLD snooping proxying
Before you configure MLD snooping proxying in a VLAN, complete the following tasks:
• Enable MLD snooping for the VLAN.
• Determine the source IPv6 address for the MLD reports sent by the proxy.
• Determine the source IPv6 address for the MLD done messages sent by the proxy.