H3C Technologies H3C S12500 Series Switches - Manual (Page 196)

180
Device Interface IP address
Switch D VLAN-interface 300 10.110.5.1/24
Switch D VLAN-interface 101 192.168.1.2/24
Switch D VLAN-interface 105 192.168.4.2/24
Switch E VLAN-interface 104 192.168.3.2/24
Switch E VLAN-interface 103 192.168.2.2/24
Switch E VLAN-interface 102 192.168.9.2/24
Switch E VLAN-interface 105 192.168.4.1/24
Configuration procedure
1. Configure the IP address and subnet mask for each interface as per Figure 54 . (Details not shown.)
2. Configure OSPF on the switches in the PIM-SSM domain to ensure network-layer reachability
among them. (Details not shown.)
3. Enable IP multicast routing, and enable PIM-SM and IGMP:
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and run IGMPv3 on
VLAN-interface 100, which connects Switch A to the stub network.
system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] igmp version 3
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim sm
[SwitchA-Vlan-interface102] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Switch B and Switch C in the same way.
# Enable IP multicast routing and PIM-SM on Switch D and Switch E in the same way. (Details not
shown.)
4. Configure the SSM group range:
# Configure the SSM group range to be 232.1.1.0/24 one Switch A.
[SwitchA] acl number 2000
[SwitchA-acl-basic-2000] rule permit source 232.1.1.0 0.0.0.255
[SwitchA-acl-basic-2000] quit
[SwitchA] pim
[SwitchA-pim] ssm-policy 2000
[SwitchA-pim] quit
# Configure the SSM group range on Switch B, Switch C, Switch D, and Switch E in the same way.
(Details not shown.)