Solution – H3C Technologies H3C S12500 Series Switches User Manual

Page 233

Text mode
Original mode

217

Solution

Use the display ip routing-table command to verify that the unicast route between the devices is

correct.

Check that a unicast route is available between the two devices that will become MSDP peer to
each other.

Verify the configuration of the originating-rp command. In the Anycast RP application environment,
be sure to use the originating-rp command to configure the RP address in the SA messages, which

must be the local interface address.

Verify that the C-BSR address is different from the Anycast RP address.

This manual is related to the following products:

H3C S9500E Series Switches H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C SecPath F5020 H3C SecPath F5040 H3C VMSG VFW1000