Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 98)

CHAPTER 9 • CLICK 512 97
Time Zone Sets the time zone of the timestamp on the data; you can view this
using HyperTerminal or another serial terminal program. The time
of events is time stamped using SmartSensor HD’s real-time clock,
which is set to UTC (GMT). Using this setting, you can tell the Click 512
to convert that time into the time zone of your choice.
Table 9.5 – Default Tab
The SmartSensor HD timestamps are referenced to the time that the front-edge of the ve-
hicle enter the detection beam. However, the event message itself will not be reported until
about one second after the back-edge of the vehicle leaves the detection beam.
Note
Invalid speed entries will show a value of 512 mph in the serial transmitted text
strings.
There are nine other tabs you can access. They correspond to the eight possible contact clo-
sure outputs the Click 512 can be configured to deal with. The other eight tabs are labeled
O1 through O8. These tabs allow you to configure the following for each alarm: the lanes
affected, over speed and under speed thresholds, length thresholds, the duration of the con-
tact closure, and the delay between detection and output.
All nine of these tabs have the following settings:
Figure 9.13 – Output Tabs