Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 25)

24 CHAPTER 4 • INSTALLING CLICK SUPERVISOR
Installing Click Supervisor
If you have a Wavetronix Install Kit, the handheld computer included in the kit comes with
Click Supervisor already installed, along with sensor software. If you don’t have an install
kit, or if you want to install on a desktop computer, follow the steps below.
Click Supervisor can be run on a Windows® PC and on ahandheld computer Everything
needed to install Click Supervisor is contained in the Click Supervisor Setup.exe file. The
setup program can install Click Supervisor on a PC, handheld computer or both.
Note
You must have administrator rights to run the setup program.
The software can be downloaded from the Wavetronix website at www.wavetronix.com. Af-
ter downloading the setup file, double-click on it to run the Click Supervisor setup wizard
(see Figure 4.1).
Figure 4.1 – Click Supervisor Setup Wizard
To install Click Supervisor on a handheld computer, you need to have ActiveSync (on Win-
dows XP or earlier) or Windows Mobile Device Center (on Windows Vista). If you do not
have these programs, they are available for download on the Microsoft website.
If you do not have ActiveSync or Windows Mobile Device Center installed on your com-
puter, skip to the next section, titled Installing Click Supervisor on a PC.
If you do have ActiveSync or Windows Mobile Device Center installed on your computer,
the setup program will detect this and the next screen that comes up will prompt you to se-
lect where you want to install Click Supervisor: a PC, a Pocket PC, or both (see Figure 4.2).