Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 22)

CHAPTER 3 • WIRING THE DEVICES 21
Note
If you are using a Click 200 in your installation, it is recommended you wire RS-485
through it if you would like to connect to a Click device.
Figure 3.2 – Wiring RS-485 Communication into the Click 200
Wiring RS-485 from a Click Device
The Click 500 series devices also have RJ-11 jacks for RS-485 communication with a com-
puter or with contact closure cards. To use, simply use an RJ-11 jumper cable to connect
the two devices.
Figure 3.3 – A Click Device Showing RJ-11 and DB-9 Jacks