Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual

Page 28

CHAPTER 4 • INSTALLING CLICK SUPERVISOR

Use these steps to install Click Supervisor on a handheld computer:
1 Ensure that you have ActiveSync or Windows Mobile Device Center installed and that

the handheld is connected to the PC and synced.

2 On the screen shown in Figure 4.2, click the checkbox labeled Pocket PC and then

select Next > >.

3 On the next screen, click Continue > > to start the installation process (see Figure

4.5). The setup program runs the Add/Remove Programs application for Windows

handheld devices. If a handheld device is connected to the computer, Add/Remove

Programs will immediately begin installing Click Supervisor on the handheld device.

If a device is not connected to the computer, Click Supervisor will be downloaded the

next time a handheld device is connected to the computer.

Figure 4.5 – Adding Click Supervisor to a Pocket PC

4 Click OK once the download is complete.

Microsoft .NET Framework

The Click Supervisor setup program will automatically detect whether Microsoft .NET

Compact Framework v1.1 is installed on your PC. If it is not installed, you will be prompted

to install it (see Figure 4.6).

This manual is related to the following products:

Click 510 (communication tester) (CLK-510) - User Guide Click 511 (digital I/O repeater) (CLK-511) - User Guide Click 512 (vehicle alert) (CLK-512) - User Guide Click 513 (traffic alert) (CLK-513) - User Guide Click 514 (event logger) (CLK-514) - User Guide