Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 132)

CHAPTER 11 • CLICK 514 131
Setting Description
Time Zone Allows you to select the time zone for presentation of data. (Smart-
Sensor HD timestamps are natively in UTC time.)
File Time Sets the duration of each log file in the recording session. The options
are hourly, daily or continuous. Continuous indicates that you simply
want to send all logged data to one file without segmentation every
hour or day.
Sensor ID Allows you to enter the Sensor ID for the SmartSensor HD. The Sen-
sor ID is used for time synchronization.
Table 11.5 – Expert Driver Settings Tab
Once you have finished, use the menu bar at the top of the screen to save your settings,
return to the Select Driver screen, and more.
˽ The Save menu allows you to save your settings. Select Save to File to save your settings
to a file. Selecting this will open a directory box, allowing you to name your settings
file. This file will always be saved in the Wavetronix folder created when you installed
Click Supervisor, under Wavetronix > ClickHome > Drivers > 514 > User. You can also
select Save to Device to save your settings to your Click 514.
Note
If you do not save your settings to your Click 514, they will be lost the next time you
power the device down.
˽ The Tools menu contains five options for working with your device. Reset > System
power cycles your device, while Reset > Factory Default restores your device to the
settings with which it was shipped. Restore will restore the driver to the settings cur-
rently saved on the Click 514, erasing any unsaved changes. Upgrade can be used to
manually upgrade to the most current firmware for your device. Hex View changes the
view of certain settings in the driver to hexadecimal.
˽ Clicking the Quit menu exits the driver and returns you to the Click Supervisor main
page.