Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 62)

CHAPTER 7 • CLICK 510 61
Note
Only event data packets can be sent, so you cannot emulate the Actuation data
mode used with a contact closure module and the SS105.
Figure 7.4 – Viewing 17’/60’ 30–60 mph Event Trafic Data in HyperTerminal
Test Pattern
Test Pattern mode is the second mode presented in the menu selection process (blue solid).
Test Pattern mode is used for testing communication channels; it does this by sending data
packets over the channel to the other Click 510 or computer. It is especially helpful for de-
bugging because it locates the break in your channel of communication. Use it when you are
connecting two Click 510 devices together or connecting a Click 510 to a computer.
This mode has two submenus on which you can specify the data packet and how it will be
sent.
1st LED 2nd LED 3rd LED 4th LED
Submenu 1
(Yellow LEDs)
1 second 0.25 – 1 second Switch -
Submenu 2
(Red LEDs)
LED flash LED sequence ASCII sequence ASCII text
Table 7.3 – Test Pattern Submenus (Yellow and Red LEDs)
Test Pattern submenu 1 allows you to select when the Click 510 sends out data packets.
Submenu 1 selections are displayed on the device as the row of yellow LEDs (see Table 7.3).
˽ 0.25 to 1 second – Sends data every 0.25 to 1 second.
˽ 1 second – Sends data every second.
˽ Switch – Sends data every time the push-button is pressed.