Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 124)

CHAPTER 11 • CLICK 514 123
Reset Red flashing –
Table 11.1 – Operating Modes and LED State
The LED state during the mode selection process can be either flashing or solid. If the cur-
rent mode is a flashing mode, the corresponding LED will flash during mode selection.
However, after a flashing mode is selected, the selected mode LED will not flash—the red
LED will flash instead.
Navigating the Menu via the Push-Button
The menu is navigated via the push-button using hold and press actions:
˽ Hold – Pressing and then holding for at least 1½ seconds allows you to enter the Click
514 mode selection process.
˽ Press – Pressing and then quickly releasing the push-button allows you to make a
selection in the menu.
The menu is used to select and run an application’s operating modes. Select a mode by
navigating through the main menu (multicolored LEDs) and the submenus (yellow and red
LEDs) as described below:
1 Enter the main menu by holding the push-button down. Continue holding the push-
button to cycle through the entire menu of modes.
2 Release the push-button once the cycle reaches the desired mode (see Table 11.1).
3 Press the push-button again to select the mode. Once selected, the mode will either
start running or, if there are submenu options, the first submenu (yellow LEDs) will
start (the first LED will light up).
4 Hold the push-button to cycle through the first submenu.
5 Release the push-button once the desired submenu selection is displayed.
6 Press the push-button again to select the mode. Once selected, the mode will either
start running or, if there are additional submenu options, the second submenu (red
LEDs) will start (the first LED will light up).
7 Hold the push-button to cycle through the second submenu.
8 Release the push-button once the desired submenu selection is displayed.
9 Press the push-button again to select the mode. The mode will now start running.
Device Setup Mode (green solid)
Device Setup mode is the second mode presented in the mode selection process. This mode
allows you to configure threshold variables and set up communications with the Click 172
or 174.
First put the device in Device Setup mode (solid green). The Click 514 is then configured
using the Click Supervisor software. See Chapters 4 and 5 of this document for instruction
on how to download and install Click Supervisor and how to connect to your device using