Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 111)

110 CHAPTER 10 • CLICK 513
Figure 10.7 – Expert Driver General Tab
Setting Description
Module Shows the name of the Click device.
Driver Names the driver you are currently working with.
Description Shows a description of the device being configured. This is only for
your information and does not affect the operation of the device.
Location Displays the location of the device being configured. This is only for
your information and does not affect the operation of the device.
Serial Number Displays the serial number of your device.
Firmware Version Shows the version of firmware your device currently has installed. If
Click Supervisor detects a discrepancy between this version and the
most current version it currently has access to, you will be prompted
to upgrade when you connect to the device.
Subnet ID Shows the subnet ID number. This option is currently not available.
Device ID Gives the ID number of the device being configured, which is used
to identify the device when you are connecting to it. By default, this
number is the last five digits of the serial number, which can be found
under the About tab or on the barcode sticker on the bottom of the
device. It is recommended that you do not change this number unless
another device on the network has the same ID number.
Table 10.2 – Expert Driver General Tab
The Comm subtab allows you to configure how the Click device communicates (see Figure
10.8 and Table 10.3).