Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 79)

78 CHAPTER 8 • CLICK 511
Figure 8.8 – Demo Kit with the Click 511 Field (left) and Base (right) Stations
Set Up Server Output (green flashing)
Set Up Server Output is the third option presented in the menu selection process. Server
output selection is done using a task instead of an operating mode. This means that as soon
as the output type has been selected, the Click 511 will return to the previous operating
mode.
This task has two submenus with which you specify the output type for server operation.
Submenu 1 determines whether the output is an alarm (inverted) or relay (pass through).
Submenu 2 determines whether fail-safe mode is entered after a client is persistently un-
discoverable.
1st LED 2nd LED
Submenu 1 (Yellow LEDs) Alarm mode Relay mode
Submenu 2 (Red LEDs) Fail-safe on Fail-safe off
Table 8.5 – Set Up Server Submenus (yellow and red LEDs)
Reset (red flashing)
The reset task is the fourth option presented in the menu selection process. The reset func-
tion will power cycle the Click 511. If the device is not responding and not communicating,
resetting the device may fix the problem.