Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 127)

126 CHAPTER 11 • CLICK 514
Figure 11.7 – Excel Spreadsheet
Reset (red flashing)
The red flashing mode resets the Click 514 to factory defaults. If a device is not responding
and not communicating, resetting the device may fix the problem. Once in reset mode, use
submenu 1 (yellow LEDs) to select which level of settings should be reset:
˽ First LED solid – Reset all settings except serial number and XML variable map.
˽ Second LED solid – Reset all settings except serial number.
After being reset, the Click 514 will return to the last mode that it was in.
Computer Configuration
The Click 514 must be configured using the Click Supervisor software. See Chapters 4 and
5 of this document for instructions on how to download and install Click Supervisor and
how to connect to your device using the software.
The Click 514 can be configured using the Expert driver (see Figure 11.8).