Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 107)

106 CHAPTER 10 • CLICK 513
Obtain the desired serial terminal program and follow the distributor’s instructions for in-
stallation.
Operating Modes
The Click 513 has two operating modes: Run mode and Device Setup mode. These modes
are accessed through the mode selection menu, which is controlled via the push-button; the
system (multicolored) LEDs light up to show which mode you are currently on. Table 10.1
shows the LED color and state associated with each operating mode or task.
Operating Mode/Task Selection LED State Operating LED State
Run Blue solid Blue solid
Device Setup Green solid Green solid
Reset Red flashing –
Table 10.1 – Operating Modes and LED State
The LED state during the mode selection process can be either flashing or solid. If the cur-
rent mode is a flashing mode, the corresponding LED will flash during mode selection.
However, after a flashing mode is selected, the selected mode LED will not flash—the red
LED will flash instead.
Navigating the Menu via the Push-Button
The menu is navigated via the push-button using hold and press actions:
˽ Hold – Pressing and then holding for at least 1½ seconds allows you to enter the Click
513 mode selection process.
˽ Press – Pressing and then quickly releasing the push-button allows you to make a
selection in the menu.
The menu is used to select and run an application’s operating modes. Select a mode by
navigating through the main menu (multicolored LEDs) and the submenus (yellow and red
LEDs) as described below:
1 Enter the main menu by holding the push-button down. Continue holding the push-
button to cycle through the entire menu.
2 Release the push-button once the cycle reaches the desired mode (see Table 10.1).
3 Press the push-button again to select the mode. Once the mode is selected it will start
running. If you selected to reset the device, the submenu of yellow LEDs will start (the
first LED will light up).
4 Hold the push-button to cycle through the options of the submenu.
5 Release the push-button once the desired option is displayed.
6 Press the push-button again to select the option. The mode will now start running.