Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 96)

CHAPTER 9 • CLICK 512 95
Parity Allows you to set parity error checking. This option is currently not
available.
Stop Bits Allows you to set the number of stop bits. This option is currently not
available.
Data Bits Shows you the number of data bits being sent. This option cannot be
changed.
Active Port Indicates on which port you are communicating with the sensor. This
option cannot be changed.
Latency Indicates the latency between the sensor and the Click device. This
option cannot be changed.
Table 9.3 – Expert Driver Comm Tab
The Autobaud subtab allows you to configure how the device autobauds (see Figure 9.111
and Table 9.4). As none of these options can currently be changed, you would only use this
tab if you needed to look at how the device’s autobaud function is currently set up.
Figure 9.11 – Expert Driver Autobaud Tab
Setting Description
Command Allows you to set the command sent from the device during the auto-
baud process. This option is currently not available.
Response Shows the response the device is expecting from the above com-
mand. This option is currently not available.
SmartSensor ID Shows the ID number of the sensor with which the Click device is cur-
rently communicating. This option is currently not available.
Server/Client Allows you to set whether the device is a server or client in a point to
multipoint setup (this option is not related to device autobauding).
This option is currently not available.
Table 9.4 – Expert Driver Autobaud Tab