Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 74)

CHAPTER 8 • CLICK 511 73
Client Blue solid Blue solid
Server Blue flashing Blue on with red flashing
Server Output Setup Green flashing –
Reset Red flashing –
Table 8.1 – Operating Modes and LED State
The LED state during the mode selection process can be either flashing or solid. If the cur-
rent mode is a flashing mode, the corresponding blue LED will flash during mode selection
(see column 2 of Table 8.1). However, once a flashing mode is selected the red LED will flash
instead of the blue LED. For example, once the Server mode is selected, the blue LED will
be on constantly, but the red LED will flash on and off.
Navigating the Menu via the Push-Button
The menu is navigated via the push-button using hold and press actions:
˽ Hold – Pressing and then holding for at least 1½ seconds allows you to enter the Click
511 menu selection process.
˽ Press – Pressing and then quickly releasing the push-button allows you to make a
selection in the menu.
The menu is used to select and run an application’s operating modes. Select an operation
mode by navigating though the main menu (multicolored LEDs) and the submenus (yellow
and red LEDs) as described below:
1 Enter the main menu by holding the push-button down. Continue holding the push-
button to cycle through the entire menu of modes.
2 Release the push-button once the cycle reaches the desired mode (see $).
3 Press the push-button again to select the mode. Once selected, the mode will either
start running or, if there are submenu options, the first submenu (yellow LEDs) will
start (the first LED will light up).
4 Hold the push-button to cycle through the first submenu.
5 Release the push-button once the desired submenu selection is displayed.
6 Press the push-button again to select the mode. Once selected, the mode will either
start running or, if there are additional submenu options, the second submenu (red
LEDs) will start (the first LED will light up).
7 Hold the push-button to cycle through the second submenu.
8 Release the push-button once the desired submenu selection is displayed.
9 Press the push-button again to select the mode. The mode will now start running.
Client Mode (blue solid)
Client mode is the first mode presented in the menu selection process. It is also the default
mode and will be running when the device is first powered on. (After you have switched to
another operating mode, the device will return to that mode after a power cycle.)