Physical features, Communication ports – Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual

Page 55

CHAPTER 7 • CLICK 510

Note

With the release of version 2.0, the Click 510 is now an application that runs on the
Click 500 series hardware platform. Some features of v2.0 operate differently than
that of the v1.0 product, which had a custom platform. The following documentation
is specific to v2.0. If you have an earlier version of the Click 510, you will need to refer
to previous documentation. Contact Wavetronix Technical Services for support.

Physical Features

The Click 510 physical features are used for easy installation and configuration.

Figure 7.2 – Diagram of the Click 510

Communication Ports

The back of the Click 510 features a 5-position connector that plugs into a T-bus connector

and provides power and RS-485 communication to the device. It also passes RS-485 com-

munication to all other devices on the T-bus. Usually, the RS-485 T-bus connection port is

the primary communication.

The top of the module has two pluggable screw terminal blocks for wiring in communica-

This manual is related to the following products:

Click 510 (communication tester) (CLK-510) - User Guide Click 511 (digital I/O repeater) (CLK-511) - User Guide Click 512 (vehicle alert) (CLK-512) - User Guide Click 513 (traffic alert) (CLK-513) - User Guide Click 514 (event logger) (CLK-514) - User Guide