Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 113)

112 CHAPTER 10 • CLICK 513
Figure 10.9 – Expert Driver Autobaud Tab
Setting Description
Command Allows you to set the command sent from the device during the auto-
baud process. This option is currently not available.
Response Shows the response the device is expecting from the above com-
mand. This option is currently not available.
SmartSensor ID Shows the ID number of the sensor with which the Click device is cur-
rently communicating. This option is currently not available.
Server/Client Allows you to set whether the device is a server or client in a point to
multipoint setup (this option is not related to device autobauding).
This option is currently not available.
Table 10.4 – Expert Driver Autobaud Tab
The other tab is the 513 tab. If you click on it, you will see tabs labeled General, Thresholds
and Output.
The 513 > General tab allows you to configure general settings for the Click 513 (see Figure
10.10 and Table 10.5).