Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 94)

CHAPTER 9 • CLICK 512 93
After you have made configuration changes on a driver and saved it to the Click device, the
word “current” will appear after that driver to indicate the driver that is currently loaded
onto the device.
Note
Changing any of the settings on any driver and saving them to the Click device will
change those settings on all drivers.
The Backups option can be used to read configurations that have previously been saved to
file. See Chapter 5 for more information.
Expert
The Expert driver allows you to configure the Click 512. The driver is divided into two tabs,
System and 512.
The System tab is divided into three subtabs: General, Comm, and Autobaud.
The General subtab contains information about the device (see Figure 9.99 and Table 9.2).
Figure 9.9 – Expert Driver General Tab
Setting Description
Module Shows the name of the Click device.
Driver Names the driver you are currently working with.
Description Shows a description of the device being configured. This is only for
your information and does not affect the operation of the device.