Installing click supervisor on a pc – Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual

Page 26

CHAPTER 4 • INSTALLING CLICK SUPERVISOR

Figure 4.2 – Selecting an Installation

If you select Computer, the program will go through the steps outlined in the next section,

Installing Click Supervisor on a PC. If you select Pocket PC, the program will go through

the steps in the section titled Installing Click Supervisor on a handheld computer. If you

select both, the program will go through both installation processes, beginning with install-

ing on the PC.

Note

Although the software can be installed on most handhelds, because of constantly
changing handheld technologies, Wavetronix can only offer technical support on the
handheld in the kit, which is a Socket Mobile 650.

Installing Click Supervisor on a PC

Follow these steps to install Click Supervisor on a PC:
1 On the screen shown in Figure 4.2, click the checkbox labeled Computer and then

select Next > >.

2 Select an installation location. The default location provided is normally “C:\Program

Files\Wavetronix.” Click Browse to choose another location (see Figure 4.3).

This manual is related to the following products:

Click 510 (communication tester) (CLK-510) - User Guide Click 511 (digital I/O repeater) (CLK-511) - User Guide Click 512 (vehicle alert) (CLK-512) - User Guide Click 513 (traffic alert) (CLK-513) - User Guide Click 514 (event logger) (CLK-514) - User Guide