Installing click supervisor – Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual

Page 24

In this chapter

˽ Installing Click Supervisor

˽ Microsoft .NET Framework

Once your Click devices are installed and wired, the next step is to install Click Supervisor,

a computer program that will help you work with your Click modules. Most Click 500 ap-

plications can be configured and monitored to some extent using the buttons and LEDs on

the module, but certain devices can be fine-tuned using Click Supervisor. These computer-

programmable devices include the following:

Click 512 – Vehicle Alert

Click 513 – Traffic Alert

Click 514 – Event Logger

In addition, any custom applications developed on the Click 500 platform have the capabil-

ity of working with Click Supervisor, if that is what the developer decides to do.

Note

If you are running Windows® Vista, you must run Click Supervisor in XP Service Pack
2 compatibility mode. To switch to this mode, right-click on the Click Supervisor icon
and select

Properties from the drop-down menu. Go to the Compatibility tab. Under

Compatibility mode, click the

Run this program in compatibility mode for: check-

box. This will enable the drop-down menu, allowing you to select Windows XP (Ser-
vice Pack 2). Hit

OK.

Installing Click Supervisor

This manual is related to the following products:

Click 510 (communication tester) (CLK-510) - User Guide Click 511 (digital I/O repeater) (CLK-511) - User Guide Click 512 (vehicle alert) (CLK-512) - User Guide Click 513 (traffic alert) (CLK-513) - User Guide Click 514 (event logger) (CLK-514) - User Guide