Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual
Page 115
114
CHAPTER 10 • CLICK 513
Note
Values in Click Supervisor will be displayed according to the units (English or metric)
selected in SSMHD.
Figure 10.11 – Approach Tabs
Setting
Description
Over Speed
If enabled, will qualify* an interval if the average speed is above the
set threshold
Under Speed
If enabled, will qualify* an interval if the average speed is below the
set threshold
Over Volume
If enabled, will qualify* an interval if the total volume is above the set
threshold
Under Volume
If enabled, will qualify* an interval if the total volume is below the set
threshold
Over Occupancy
If enabled, will qualify* an interval if the percentage of occupancy is
above the set threshold
Under Occupancy
If enabled, will qualify* an interval if the percentage of occupancy is
below the set threshold
Table 10.6 – Thresholds Tab
*When AND logic is used, intervals do not
qualify until ALL enabled criteria are met.
The 513 > Output tab contains information about which time zone is configured for the
Click 513 (see Figure 10.12 and Table 10.7).