Wiring through a 5-screw terminal – Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual

Page 18

CHAPTER 2 • T-BUS BASICS

Figure 2.1 – Wiring Power into the Click 200

Wiring through a 5-screw Terminal

If you choose not to use a Click 200, or if you have one but prefer not to wire through it,

you can also connect power through a 5-screw terminal block connected to the end of the

T-bus.

To provide power to a T-bus through a 5-screw terminal block, follow these steps:
1 Attach a male 5-screw terminal block to the left end of the T-bus by aligning it with the

first connector and pushing the modules together.

2 Connect the black (ground) and red (+24 VDC) wires from the Click 201/202/204

into the top two screw terminals in the 5-screw terminal block (see Figure 2.2 for the

5-screw terminal block pinout).

Figure 2.2 – 5-screw Terminal Block Pinout

Note

To disconnect a 5-screw terminal block from a T-bus connector, use a small, thin item,
such as a small screwdriver, to gently pry the two modules apart.

This manual is related to the following products:

Click 510 (communication tester) (CLK-510) - User Guide Click 511 (digital I/O repeater) (CLK-511) - User Guide Click 512 (vehicle alert) (CLK-512) - User Guide Click 513 (traffic alert) (CLK-513) - User Guide Click 514 (event logger) (CLK-514) - User Guide