Wiring out of a t-bus – Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual

Page 19

background image

18

CHAPTER 2 • T-BUS BASICS

Wiring out of a T-bus

Occasionally you will need to provide power and communication to devices in your cabinet

that are not on a DIN rail or on a T-bus. In these cases, you can connect a female 5-screw

terminal block to the right side of your T-bus and wire +DC, ground and communication

from there into the device.

This manual is related to the following products:

Click 510 (communication tester) (CLK-510) - User Guide Click 511 (digital I/O repeater) (CLK-511) - User Guide Click 512 (vehicle alert) (CLK-512) - User Guide Click 513 (traffic alert) (CLK-513) - User Guide Click 514 (event logger) (CLK-514) - User Guide