QuickLabel Designer Pro - Manual (Page 77)

- 77 -
actually prints the label and reads the RFID data. It might not be immediately after you issue the
print command, the job might be delayed in the spooler out of several reasons.
When you enable the error logging, select the text file into which you would like to store error mes-
sage. The error messages will help you resolve the error situation. Usually the conditions you have
defined in the Storage Fields tab are not met.
Note: RFID data is always stored in the XML data structure.
Changing Printer Settings
Changing Common Printer Settings
When you start designing a label you tell the labeling software to what printer the label should be
connected. Each label file remembers the printer settings for the selected printer driver on the label.
As an example, you will change the printing speed and darkness. To change the printer settings, do
the following:
1. Go to File – Printer Settings. The window with the printer settings will open.
2. Open the Options tab.
3. Change the Speed and Darkness options.
4. Click on the OK button.
5. Save the label by clicking the button in the Standard toolbar or selecting the com-
mand Save in the File menu.
Printer driver properties
Note:
Any changes in the printer settings dialog box will be saved to the label and applied to future print
actions.
You can also change the printer settings right before the label is printed.
1. Select the Print command in the File menu.
2. Go to the Printer tab.
This tab allows you to change the printer just before printing begins, but it also enables
you to change common printer settings like speed, darkness and print direction.
Note:
Changes to the settings in the Printer tab will not be saved in the label but used only at print time.