Comtech EF Data DTMX5000 SpectraCast - Manual (Page 51)

DTMX5000 IP Gateway Operation
Rev. 1 3–15
3.2.4.1 Output Bit Rate
Path: Edit CFG.INI Parameters/DVB Mapping Parameters/Output
Bit Rate.
Description: Specifies the output bit rate of the Gateway. This is the gross
output bit rate, so that if the framing used is 204, the payload
data rate will be somewhat lower (188/204) than the gross
rate. Enter the output bit rate in the space provided.
Note: The unit must be rebooted in order for settings to take effect.
3.2.4.2 PAT Rate
Path: Edit CFG.INI Parameters/DVB Mapping Parameters/PAT
Rate.
Description: Specifies the rate, in tables per seconds, at which the Program
Association Table (PAT) packets will be sent. The PAT
defines a structure from which the PMTs may be found.
Enter the number for the rate at which the PAT packets will
be sent.
Note: The unit must be rebooted in order for settings to take effect.
3.2.4.3 PMT Rate
Path: Edit CFG.INI Parameters/DVB Mapping Parameters/PMT
Rate.
Description: Specifies the rate, in tables per seconds, at which the Program
Map Table (PMT) packets will be sent. The PMT defines the
various PIDs of which a program is made.
Enter the number for the rate at which the PAT packets will
be sent.
Note: The unit must be rebooted in order for settings to take effect.