Comtech EF Data DTMX5000 SpectraCast - Manual (Page 25)

Rev. 1 2–1
2
Chapter 2.
INSTALLATION
This section provides important information concerning the installation of the
DTMX5000.
2.1 Overview
Note: For security reasons, the unit’s vital parameters can only be configured through a
direct serial connection to a local terminal. The remaining parameters can be configured
either via the local terminal or remotely via a Telnet terminal.
An optional VGA display also can be connected to the DTMX5000 using a 15-pin cable
for viewing, boot, and operational messages.
CAUTION
Never install the unit where it may be exposed to rain or moisture. Water in
the unit may damage components and create a shock hazard.
Never remove the cover. This multiplexer has very sophisticated circuitry
that should only be serviced by a fully trained technician.
Removal of the cover might:
••••
Void the warranty
••••
Allow ESD damage to components
••••
Create a shock hazard