Comtech EF Data DTMX5000 SpectraCast - Manual (Page 102)

DTMX5000 MIB File DTMX5000 IP Gateway
4–22 Rev. 1
4.2.6 Static Users Parameters
A static user is a definition of a valid host in the system. When a static user is created, the
Gateway permits traffic to a specific static host. Parameters for specific static users can
be defined in the Gateway via SNMP. When defining parameters for static users, the user
defines the host IP address, MAC address, and Group number (PID).
Static users parameters are stored in a static user table in the Gateway (cbConfigSTU-
Table). The index of the table is the static user’s IP Address. Static users can be enabled
or disabled by SNMP commands. Each static user may be defined to work with a speci-
fied group, and with a specified PIB.
Static Users Parameters consists of the following:
•
Static User IP Address
•
Subnet Mask
•
Group
•
MAC
•
Minimum Rate
•
Maximum Rate
4.2.6.1 Static User IP Address
MIB Object: cbStaticUserIP
OID: iso(1).org(3).dod(6).internet(1).private(4).enterprises(1).
efdata(6247).spectracast(3).DTMX5000(1).cbConfig(2).
cbConfigSTUTable(5).
cbStaticUserTable(1).cbStaticUserEntry (1).cbStaticUserIP(1)
Description: IP address of the static user.
Data Types: IP address
Access: Read-write
4.2.6.2 Subnet Mask
MIB Object: cbStaticUserMask
OID: iso(1).org(3).dod(6).internet(1).private(4).enterprises(1).
efdata(6247).spectracast(3).DTMX5000(1).cbConfig(2).
cbConfigSTUTable(5).
cbStaticUserTable(1).cbStaticUserEntry (1).cbStaticUserMask(2)
Description: If the user is a network, this parameter defines, together with the IP
address, the network’s address. If the user is not a network, the subnet
mask should be:
255.255.255.255
Data Types: INTEGER
Access: Read-write