Comtech EF Data DTMX5000 SpectraCast User Manual
Page 179
DTMX5000 IP Gateway
Index
Rev. 1
I–3
Standard References......................................C–2
Starting a Session ...........................................B-3
Starting the DTMX5000.................................2–6
Static Users Parameters................................4–22
System Details...............................................C–3
System Requirements.....................................B-7
T
Telnet Terminal ..............................................2–8
Terminating a Session ....................................B-7
The CCU Cannot Register a User in the
Gateway..................................................5–6
The CCU Does Not Communicate with the
Gateway..................................................5–4
The CCU Logfile Mechanism ......................B-27
The Gateway Does Not Power Up .................5–2
The Gateway Does Not Reply to Ping from the
Control and Management Interface ........5–2
The Gateway Does Not Reply to Ping from the
Transportation Interface .........................5–2
The Gateway Does Not Reply to SNMP Set or
Get Commands .......................................5–3
The Gateway Does Not Reply to Telnet but
Does Reply to SNMP and Terminal
Communication ......................................5–6
The Gateway Does Not Reply to Telnet/FTP
Users.......................................................5–3
The Gateway Statistics indicate a Large Number
of Discarded Packets ..............................5–5
The Gateway's Output is Connected to a DVB
Multiplexer's Input but the DVB
Multiplexer Indicates that there is NO TS
Input. ......................................................5–4
The Modulator Cannot Synchronize with the
Transport Stream (TS) Generated by the
Gateway .................................................5–3
TROUBLESHOOTING................................5–1
Troubleshooting .............................................5–1
U
Uninstalling the CCU Application...............B-11
V
VGA Display .................................................1–9
W
Write Parameters to CFG.INI and Reset......3–21
Write Parameters to CFG.INI without Reset3–22
Writing the CFG.INI Parameters .................3–21