Comtech EF Data DTMX5000 SpectraCast - Manual (Page 42)

Operation DTMX5000 IP Gateway
Rev. 1 3–6
3.2.1.5 Quality of Service Mode
Path: Edit CFG.INI Parameters/General Parameters/Quality of
Service Mode
Description: Specifies the behavior of the unit in the event that a
subscriber tries to exceed their maximum rate and there is
free available bandwidth. This parameter is applicable only if
the QoS parameter is set to Enabled.
•
Select Permissive to enable a subscriber to exceed the
maximum rate if free bandwidth is available.
•
Select Restrictive to prevent the subscriber from
exceeding the maximum rate under any circumstances.
Note: The unit must be rebooted in order for settings to take effect.
3.2.1.6 Maximum Allowable Delay
Path: Edit CFG.INI Parameters/General Parameters/Maximum
Allowable Delay
Description: Specifies the maximum amount of time, in milliseconds, that
a datagram can be delayed in the unit. If the delay is more
than the specified number of milliseconds, the datagram is
discarded.
Enter the name specifying the maximum delay.
Note: The unit must be rebooted in order for settings to take effect.
3.2.1.7 Encryption
Path: Edit CFG.INI Parameters/General Parameters/Encryption.
Description: Specifies if subscriber’s packets can be encrypted on the
DTMX5000 Link.
Select Enabled to enable subscribers to request encryption.
Select Disable to specify that encryption will not be activated,
regardless of a subscriber’s request.
Note: The unit must be rebooted in order for settings to take effect.