Comtech EF Data DTMX5000 SpectraCast - Manual (Page 32)

Installation DTMX5000 IP Gateway
2–8 Rev. 1
2.3.3 Telnet Terminal
2.3.3.1 Connect the Telnet Terminal
The DTMX5000 as parameters can be configured and edited through a remote telnet
terminal, connected via the Control and Management LAN connection of the
DTMX5000. The Telnet terminal can run on any machine that has a TCP/IP connection
with the DTMX5000. This connection can be local or remote, via the Internet.
Note: For security reasons, the unit’s vital parameters can only be configured and edited
through a local connection.
To connect the Telnet terminal to the DTMX5000 and establish a communications link
between them, proceed as follows:
Notes:
1. The Telnet terminal is any Telnet terminal application running on a machine that
has a TCP/IP connection with the DTMX5000. All Windows

operating
systems contain a Telnet application.
2. Verify the TCP/IP connection between the machine running the Telnet terminal
and the unit, use Ping to the unit.