Comtech EF Data DM240XR - Manual (Page 64)

DM240XR High-Speed Digital Modulator User Interfaces
MN-DM240XR– Revision 13 4–42
4.8.1 Connecting the Terminal
1. Connect the Terminal to the Terminal Connector (J1) on the rear of the unit using the RS-
232 null modem Cable.
2.
Verify that your emulation software is set to the following:
 8 data bits
 no parity
 1 stop bit
 No Flow Control
Modify the selection, if necessary, to match the settings (the Front Panel ‘SYSTEM’ Sub-
Menu contains all the Terminal Emulation Controls).
4.8.2 Terminal Screens
Figure 4-5. Main Menu
Note: The GIG Ethernet Terrestrial Card is only displayed when the Ethernet Data Interface is
installed.