Comtech EF Data DM240XR User Manual
Page 51
DM240XR High-Speed Digital Modulator
User Interfaces
MN-DM240XR– Revision 13
4–29
RECEIVE TIMEOUT:
{X.X MINUTES}
This value is factory set, and should only be adjusted as directed
by your Network administrator or Radyne Customer Service.
REPLY TIMEOUT: {XX secs}
This value is factory set, and should only be adjusted as directed
by your Network administrator or Radyne Customer Service.
STREAM ALARM PER:
{0 to 59 secs}
A setting of “0” indicates that there will be no major alarm
set on loss of input data
A setting of 1 to 59 seconds will enable TX Major Alarm
“STREAM” on loss of input data once the number of seconds
has passed and the alarm criteria exist without clearing.
HW/FW CONFIG (menu)
DM240:
{NORMAL, DEMO}
Displays the DM240XR feature status
FIRMWARE REV:
{"Status Only"}
Displays the Firmware revision level.
M&C REV:
{"Status Only"}
Displays the Monitor and Control revision level.
MAIN BOARD:
{sub-menu}
SERIAL NUMBER: {"Status Only"}
PC NUMBER:
{"Status Only"}
ASSEMBLY #:
{"Status Only"}
FEATURES: {sub-menu}
xxxx.xxxx.xxxx
Unique Feature Code ID
UDGRADE LIST (sub menu) List Features Status
INTFC 1 TYPE:
{“Status Only”}
Displays interface type installed in slot 1
INTFC 1 REV {“Status Only”}
Displays FPGA REV of interface in slot 1
INTFC 2 TYPE:
{“Status Only”}
Displays interface type installed in slot 2
INTFC 2 REV {“Status Only”}
Displays FPGA REV of interface in slot 2