Comtech EF Data DM240XR - Manual (Page 177)

DM240XR High-Speed Digital Modulator Web Browser Quick Setup Guide
MN-DM240XR– Revision 13 C–3
and data rates cannot be overridden. The Confirmation command is located under PASSWORD
SETUP/PREFERENCES.
2. USER 1 : This will allow the operator to change the user name, assign the Access group,
authorized password for “USER 1”. Upon entering the following fields will be displayed:
a. ACCESS GROUP:
b.
This will allow the assignment of “No Group”, “ADMIN”,
“OPER”, or GUEST to USER 1.
AUTH PASSWORD:
c.
This will allow for the entry of the password for USER 1.
USER RESET: Using this command will allow the factory defaults (as listed in the
table above) to be restored to USER 1. This can be used in the event that USER 1 is
locked out due to password restriction.
3. USER 2 : This has the same menu structure as USER 1.
4. USER 3 : This has the same menu structure as USER 1.
Radyne’s Web configuration allows for the support of 3 user profiles. These are configured
through the ‘PASSWORD/SETUP ACCESS section in the Web Browser.
C.2.1 Change Web User Name
Any of the three available user names can be modified.
1. Go to Submenu, press then move the cursor to any position
and press along with the ‘Right Arrow’ key to clear all text to the right of
the cursor.
2. Use the arrow keys and the numerical keypad to set the desired user name. Press
to accept the changes.
C.2.2 Change Authentication Password
1. Go to Submenu, press ‘Down Arrow’ to access its corresponding lower level
sub-menus.
2. Go to Submenu, then move the cursor to any position
and press along with the ‘Right Arrow’ key to clear all text to the right of the
cursor.
3. Use the arrow keys and the numerical keypad to set the desired password. Press
to accept the changes.