Comtech EF Data DM240XR - Manual (Page 105)

DM240XR High-Speed Digital Modulator SNMP
MN-DM240XR– Revision 13 8–11
normal(0),
bypassed(1)
}
ACCESS read-write
STATUS current
DESCRIPTION
"Enables/disables the inner forward error correction.
The modulator is considered in a test mode when the
inner FEC is bypassed."
::= { radSNMPModNVStatus 48 }
radRfSwitchRedundancyMode OBJECT-TYPE
SYNTAX INTEGER {
manual(1),
autoRevert(2),
backup(3)
}
ACCESS read-write
STATUS current
DESCRIPTION
"If the modulator is connected to the prime
side of the switch then manual and
auto revert modes are available. Otherwise,
if modulator is connected to backup side
then only manual and backup modes are
available."
::= { radSNMPModNVStatus 49 }
radRfSwitchActivateSide OBJECT-TYPE
SYNTAX INTEGER {
primary(1),
backup(2)
}
ACCESS read-write
STATUS current
DESCRIPTION
"Activates the primary or backup side of
the RF switch."
::= { radSNMPModNVStatus 50 }
radRfSwitchFaultTestMode OBJECT-TYPE
SYNTAX INTEGER {
normal(1),
faulted(2)
}
ACCESS read-write
STATUS current
DESCRIPTION
"Allows the assertion of the fault signal
to the RF switch for test purposes"
::= { radSNMPModNVStatus 51 }
radPhaseNoiseGeneratorEnabled OBJECT-TYPE
SYNTAX INTEGER {
disable(0),
enable(1)
}
ACCESS read-write
STATUS current
DESCRIPTION
"Enables/disables the phase noise generator."
::= { radSNMPModNVStatus 52 }
radPhaseNoiseProfileIndex OBJECT-TYPE
SYNTAX INTEGER (1..16)
ACCESS read-write
STATUS current
DESCRIPTION
"Selects the phase noise profile."
::= { radSNMPModNVStatus 53 }
radPlHeaderScramblerSeqIndex OBJECT-TYPE
SYNTAX INTEGER (0..2000)
ACCESS read-write