beautypg.com

Comtech EF Data DM240XR User Manual

Page 37

background image

DM240XR High-Speed Digital Modulator

User Interfaces

MN-DM240XR– Revision 13

4–15

Prime Column FEC packets must arrive on Prime UDP
port + 2

Prime Row FEC packets must arrive on Prime UDP port
+ 4

SOURCE IP ADDR: {XXX.XXX.XXX.XXX}

This menu is displayed in when the Prime IP Address is configured for

Multicast mode: The user can specify a source IP address for the prime to

listen to. When a non-zero IP address is entered, the prime will only accept

multicast packets addressed to it on its prime port from the specified source.

When an IP address of zero is entered, the prime will accept multicast

packets addressed to it on its prime port from any source.

In Unicast mode: This field is hidden when the Prime IP
Address is set for Unicast Mode. The prime accepts
Unicast packets addressed to it from any source.

UNICAST IP ADDR: { XXX.XXX.XXX.XXX }

Identifies the Unicast IP Address

BACKUP ETHERNET: Scroll down to configure the IP selection for the prime UDP

port

BACKUP IP ADDR: {XXX.XXX.XXX.XXX}

In Multicast mode: Allows the operator to enter the
backup multicast IP address. The unit will only accept
valid multicast IP address entries in the range of
224.000.000.000 to 239.255.255.255

In Unicast mode: This field is hidden and has no affect.
The backup IP address is the same as the prime IP
address

BACKUP UDP PORT: {XXXXX}

This is the destination UDP port on which packets
addressed to the prime IP address will arrive.

When operating in COP3 RTP FEC mode:

Backup Column FEC packets must arrive on Prime UDP
port + 2

IMPORTANT

This manual is related to the following products: