Ch09_remote_operations.pdf, Chapter 9. remote operations – Comtech EF Data DM240XR User Manual
Page 115

MN-DM240XR– Revision 13
9–1
Chapter 9. Remote Operations
When new features are added to Radyne Corp. equipment, the control
parameters are appended to the end of the Non-Volatile Section of the Remote
Communications Specification, and status of the features, if any, are added at
the end of the Volatile Section. If a remote M&C queries two pieces of Radyne
Corp. equipment with different revision software, they could respond with two
different sized packets. The remote M&C MUST make use of the non-volatile
count value to index to the start of the Volatile Section. If the remote M&C is
not aware of the newly added features to the product, it should disregard the
parameters at the end of the Non-Volatile Section and index to the start of the
Volatile Section.
Before creating any software based on the information contained in this
document, contact the Radyne Corp. Customer Service Department
(602-437-9620) to find out if the software revision for that piece of equipment
is current and that no new features have been added since the release of this
document.
9.1
DM240XR Opcode Command Set
The DM240XR Opcode Command Set is listed below.
9.2
Modulator Command Set