1 introduction, 2 ethernet management interface protocols, 1 simple network management protocol (snmp) – Comtech EF Data CDD-562AL User Manual
Page 83: 2 telnet interface, 3 http web server interface
CDD-562AL/564A/L Multi-Channel Demodulator
Revision 0
Ethernet-based Remote Product Management
MN-CDD562AL564AL
7–1
Chapter 7. ETHERNET-BASED
REMOTE PRODUCT
MANAGEMENT
7.1
Introduction
Ethernet-based Remote Product Management of the CDD-56xA/L Multi-Channel Demodulator is
available using the rear panel RJ-45 10/100 BaseT Ethernet Traffic/M&C port.
The M&C port is available only when Dedicated Management Port operation is enabled.
7.2
Ethernet Management Interface Protocols
A user-supplied PC is required for Ethernet-based remote monitor and control (M&C) of the
CDD-56xA/L. Three separately-operated protocols are available:
• Simple Network Management Protocol (SNMP)
• Telnet Interface
• HTTP Web Server Interface
7.2.1
Simple Network Management Protocol (SNMP)
SNMP requires these user-supplied items:
• Network Management System (NMS)
• Management Information Base (MIB) File Browser
7.2.2
Telnet Interface
Telnet requires these user-supplied items:
• User PC
• Command-Line Interface (CLI)
• Terminal emulation program installed on the user PC
7.2.3
HTTP Web Server Interface
The Web Server Interface requires these user-supplied items:
• User PC