Comtech EF Data CDD-562AL - Manual (Page 238)

CDD-562AL/56xA/L Multi-Channel Demodulator Revision 0
Dedicated Management Port MN-CDD562AL56xAL
C–6
C.4.3 Route Table requirements
You must use Route Tables to allow local and remote M&C access when in Router Mode. See Figure
C-6.
Note, because the CDD-564A/L is a demodulator, there is no issue of sending it over the WAN interface.
C.4.3.1 Steps to set Route Tables to allow local M&C access
1. From the CLI Main Menu, type R to go to the Route Table menu.
2. On the Route Table menu:
a. Type a Route number to change an assigned Route
b. Or type
D to delete an assigned route
3. Type S to save the change.
Figure C-6. CDD-564A/L Route Tables
1