Comtech EF Data CDD-562AL - Manual (Page 151)

CDD-562AL/564A/L Multi-Channel Demodulator Revision 0
Telnet and CLI Operation MN-CDD562AL564AL
9–49
• Packets are filtered because an Off-line modem is receiving packets from WAN port.
Filtered – Unknown Reason Code
• Packets dropping because of reasons unknown
Filtered – Flow Correlator
• Packets are filtered because of incorrect establishment of SAT-to-SAT traffic. This counter is
seen typically on the out-bounding Hub modem in point-to-multipoint setup.
Filtered – Management Path
• Not used.
Filtered – WAN Scaling
• Internal Error occurred during WAN scaling sub process in processing packet.
Filtered – Ping
• Ping packets were received but PING feature was disabled.
Filtered – Access Control
• Packets are received while “Access List” control is enabled but IP address does not match the
access list database.
Filtered – Vipersat MCP
• Internal Error occurred while processing Vipersat Multi command messages.
Filtered – Vipersat UCP
• Internal Error occurred while processing Vipersat Uni-command messages.
Filtered – Codeload
• Internal error occurred while processing Codeload messages.
Filtered – Multicast
• A multicast packet is received but there is no application associated with it.
Filtered – Bad Packet
• Malformed packet is received. This may be due to internal or external error.
Filtered – Route
• Applies to Vipersat Remote only – when a packet is received from the WAN and the Route Table
contains a route to transmit that packet to the WAN, the packet will be filtered to prevent a
routing loop.
Filtered – Vipersat Remote
• Packet filtered due to QoS Rule configured to filter.
Filtered – QoS Rule
• Packet filtered due to QoS Rule configured to filter.
Filtered – Vipersat Loop
• Packet filtered due to Vipersat loop (a modem configured as a Vipersat Remote Expansion unit
and default route set to 0.0.0.0/0).