Comtech EF Data ODM-840 - Manual (Page 90)

ODM/R-840 Outdoor Remote Router Revision 0
Ethernet-based Remote Product Management MN-ODM840
5–2
5.2 Ethernet Management Interface Protocols
The user PC facilitates access to Ethernet‐based remote monitor and control (M&C) of the
ODM/R‐840 through two separately‐operated protocols:
• Simple Network Management Protocol (SNMP). This requires a user‐supplied Network
Management System (NMS) and a user‐supplied Management Information Base (MIB) File
Browser.
• The ODM‐840 Web Server (HTTP) Interface. This requires a compatible user‐supplied Web
browser such as Internet Explorer.
5.2.1 Ethernet Management Interface Access
Access to the ODM/R‐840 Ethernet
Management Interface requires
the user to specify the unit
Management IP Address. This
address may be obtained from the
ODM/R‐840 Serial Interface, upon
power‐up of the unit, via use of a
terminal emulator connected with
a user‐supplied adapter cable to
the 19‐pin serial ‘CONSOLE/
REDUNDANCY’ port. As shown, a
number of operational parameters
(including the unit factory‐default
IP addresses) are displayed.
The default (factory‐assigned) IP addresses are provided in the table that follows (if otherwise
assigned, the user may use the last column to write down the IP addresses for future reference):
Description Default Address User-assigned Address
Traffic/Management IP Address 192.168.1.12 ____________________________
See Chapter 6. SERIAL‐BASED REMOTE PRODUCT MANAGEMENT for details on
setting up and using the ODM/R‐840 Serial Interface.