Comtech EF Data ODM-840 - Manual (Page 73)

ODM/R-840 Outdoor Remote Router Revision 0
Installation MN-ODM840
3–23
3.3.4.3 Field-Fabricated User Cabling
3.3.4.3.1 Fabricating an AC Power Cable
To fabricate a site‐specific AC power cable (for use only with ODM‐840 units), see the wire list in
Figure 3‐15. Any fabricated cable must use ITT Cannon P/N KPT06B‐12‐35 as the P1 mating
connector.
AC POWER CABLE WIRE LIST
FROM PLUG WIRE TO P1 CONNECTOR PIN SIGNAL DESCRIPTION
BLACK ‘A’ LINE (L1)
WHITE ‘B’ NEUTRAL (L2)
GREEN ‘C’ GROUND (GND)
Figure 3-15. AC Power Cord (REF CEFD P/N CA-0000435)
3.3.4.3.2 Fabricating a Serial Communication Cable
To fabricate a site‐specific Serial Communication Cable (for use with ODM‐840 or ODMR‐840
units) see Table 2‐2 in Sect. 2.2.3.1 of Chapter 2. ODM/R CONNECTIONS for the
‘CONSOLE/REDUNDANCY’ connector pinouts. Any fabricated cable must use ITT Cannon P/N
KPT06J14‐19P (MS3116J14‐19P) as the mating connector.
SERIAL COMMUNICATION CABLE WIRE LIST
FROM TO SIGNAL DESCRIPTION
P1-B J1-5 GND
P1-C J1-3 RX EIA-232
P1-M J1-2 TX EIA-232
Figure 3-16. Serial Communication Cable (REF CEFD P/N CA-0000722)